Suspension of Bows of Wire

Materials and tools:

  1. 0.8 and 0.3 mm thick wire
  2. pliers;
  3. round nose pliers;
  4. paper, pencil, ruler;
  5. brush (pen);
  6. and depending on the jewelery, rings, earrings, etc.

Step 1

On a piece of paper, mark 5 points at a distance: 0; 1; 2; 3 and 4 cm (or, as shown in the picture in inches 0, 0.5; 1; 1.5 and 2). And draw a sketch of a bow (see figure).

Take the wire with a thickness of 0.8 mm and bend according to the sketch.

Step 2

Getting to braid. Take the wire with a thickness of 0.3 mm and wrap the end around the base. Now we begin to weave, the weaving technique is shown in Figure 7 and in the other figures are also clearly visible.

We weave to the end, while the coils are better laid rather tightly, so the bow will turn out more beautiful. At the end we tie a knot.

Warning! Wire does not bite off.

Step 3

Using a brush or pencil, bend the ends of the bow to the middle.

Step 4

We bite off one end of a thick wire, leaving 2-3 cm. We pass through the opposite end of the bow and lightly tighten both ends. Then do 2-3 turns in the middle of the bow and bite off the excess. All nodule ready.

Step 5

Bend the end of a thick wire, giving it the shape of a ribbon. And just like in Step 2, we do the braid.

Step 6

The second ribbon bow is also. Just repeat Step 2 and 5. We tie a small knot with a thin wire, bite off the excess and gently hide the end.

Finally, we make a couple of turns around the node.



Related News:


Great-grandmother's cat
Bactus
How to find your favorite song on the Internet
Decorating a Recipe Book
Ideas for making birds from different materials
How to clean the old pan - a method proven over the years
How the color of the furniture affects the character of the child
Bow Tie